By Admin 
As soon as the winter season arrives, people like to take bath with hot water. In such a situation, the use of geyser or immersion rod in homes also increases. Most of the people use Emerson rod because it is cheap. However, after using it for a long time, a white crust like layer of calcium and magnesium present in water accumulates on the rod. This layer reduces the working capacity of the rod.
Due to which water takes more time to heat and electricity consumption also increases. If such a layer has accumulated on your rod too, then there is no need to panic. You can clean it very easily with some normal things present in the house. So today let us tell you that if a white sheet gets stuck on the immersion rod, then with what things kept in the kitchen you can clean it.
clean with vinegar
Vinegar is considered very effective in removing the white layer on the immersion rod. For this, take so much water in a bucket or deep vessel that the rod is completely submerged. Now add half to one cup of vinegar in it and keep the rod immersed in this water for 30 minutes to 1 hour. If the white layer on the rod is thick then leave it overnight. After this, take out the rod and rub it gently with a soft scrubber and wash it with clean water. Now within a few minutes your rod will start looking like new.
Homemade recipe of lemon and salt
The mixture of acid and salt present in lemon helps in dissolving the white layer of the immersion rod. For this, first of all extract the juice of two to three lemons, add one spoon of salt in it and make a thick paste. Now apply this paste on the layer accumulated on the rod and leave it for 15 to 20 minutes and then rub it with an old toothbrush and wash it with clean water and dry it. This will make your immersion rod brand new and shiny.
Baking soda is also an effective solution
If the white layer on the immersion rod has accumulated too much then baking soda is considered to be the best solution. For this, make a paste by mixing two to three spoons of baking soda with some water. Now apply this paste on the rod and leave it for 20 to 30 minutes. Then rub gently with a sponge scrub and wash with clean water. This will make your rod completely clean.
Keep these things in mind to increase the life of the rod
If you also want to run the immersion rod for a long time, then it is necessary to clean the rod once every 15 to 20 days. At this time the rod not only heats water faster but electricity consumption also reduces and the lifespan of the rod doubles.
Also read: How much uranium is required to make an atomic bomb, what other things are required?