To make a drone, you will need a frame, motor, propeller, electronic speed controller, a flying controller, battery and a radio transmitter/receiver.

The frame is the basis of your drone. It is X -sized for Quordcopters. After opening the frame kit, keep the assembly instruction carefully and assemble your frame. Tighten all the screws well, but note that it is not too tight.

After this, add the motor to the frame and make sure that it is in the right direction. The motor drives the propeller so that drones are able to fly.

After this, sell the electronic speed controller with its respective motor wire. To prevent any accident, use heat shrink tubing for insulation.

The power distribution connects the board to the electronic speed controller. Place it at the center of the frame and add the power connection required to the electronic speed controller and battery. Flight controller’s job is to keep the drone stable at the time of flight. With this, the receiver enables remote control. The flight controller is placed in the center of the frame and connect it to the wire with the receiver and electronic speed controller.

Finally connect the propeller to motors. After this, to celebrate the system, use flight conference software like betflight. After this, run small tests and your drone is ready.